Next to verifying data in the Data inspector, you can also view telematics data in the Telematics Raw Data section. 

To show the exact data you wish to analyse you can use the filters above the table that holds all the data.

You can filter on device, to see only the data from a specific Railster (the remote condition monitoring device installed on your asset) in the table. the name of the asset it's connected to will appear right next to the device number. If you do not know the serial number of the Railster, you can enter the name of the asset in the "Asset" field instead.

You can also select a specific time range, either to view recent data, or historical data from one of your assets. To select a time frame you set a start date and an end date using the drop down calendars at the top of the page.

Another filter option is the filter on the type of data you wish to see. This means that you can e.g. select only fault code, fuel or low battery information. 

Combine the filters to view and analyse specific information about an asset during a defined time frame.

The filtered results will automatically be shown in the table at the bottom of the page. 

You can also select the columns you wish to show in the table. This way you only see the information that's relevant to you.

Did this answer your question?